Combined Harbour- and Seagoing Tug Bugsier 2 and 3
Scale: 1/250
Skill Level: difficult
Length: 132 mm (5.2 inch)
These two newer-design tugs are a familiar sight in the port of Hamburg - both models can be optionally built with full hull and stand.
Bugsier 2 and 3 by the well-known designer Till Schade offer a high level of attention to detail and at the same time a manageable number of parts. If you want, you can build the interior of the bridge on both tugs. The underwater hull and an attractive stand are also included for both models in the model kit.
The two tugs differ only slightly, but the small differences are of course taken into account in our model kit. The construction is great fun and at the end there is a beautiful duet, which looks great in both the diorama and the display case.
The model highlights:
- 2 models included
- Waterline or full hull model possible
- With display stand
- interior of the bridge included
- detailed winches
Product type | Papermodel |
---|---|
Manufacturer | HMV Hamburger Modellbaubogen Verlag |
Scale | 1/250 |
Designer | Till Schade |
Difficulty | difficult |
Sheet size | DIN A4 |
Sheets | 8 |
Parts | 972 |
Parts without alternative parts | 808 |
Length | 132 mm (5.2 inch) |
Bauanleitung | German, English, French, Spanish, Russian, Japanese, Pictures |
Technical data:
- Launch: 2006, K. Ladies, Netherlands
- Commissioning: 2006
- Length: 32.80 m
- Width: 11.75 m
- Propulsion: 2x Aquamaster Tractor rudder propellers
- Machines: 2x Deutz MWM 9 M 628
- Power: 5576 HP
- Speed: 13 knots
- Bollard pull: 63t
The two tugs Bugsier 2 and 3 were commissioned by the Bugsier shipping company in Hamburg and put into service in 2006. They are classified as combined harbor and sea tugs. There is enough equipment on board to be able to carry out towing tasks at any time, even on the high seas.
After the Bugsier shipping company was taken over by Fairplay Towage, both tugs have now been painted blue. However, our model shows them both in the original, typical Bugsier color scheme.